Si3 Deduplication Hardware Requirements
Copyright © SEP AG 1999-2020. All rights reserved.
Any form of reproduction of the contents or parts of this manual is allowed only with the express written permission from SEP AG. When compiling and designing user documentation SEP AG uses great diligence and attempts to deliver accurate and correct information. However, SEP AG cannot issue a guarantee for the contents of this manual.
Si3 hardware requirements
- For the minimum Si3 hardware requirements that apply to SEP sesam Si3 deduplication server, see Hardware requirements.
- For details on the required Java version, see Java Compatibility Matrix. Si3 is not mandatory, therefore there is no dependency rule in the RPM/DEB packages for it.
- When estimating the maximum size for a deduplication store, you have to ensure that there is enough space available for dedup trash or the deduplication store will run out of space. You should calculate the required disk space based on the representative sample of your full backup and add the amount of extra space equal to approx. 50% of the representative full backup.
To avoid issues arising from combination of too large Si3 deduplication stores and inefficient hardware, the maximum initial Si3 deduplication store size is restricted to 40 TB since Tigon V2 (18.104.22.168). This restriction is valid when creating a new Si3 deduplication store in GUI. Note that customers with special requirements for larger Si3 deduplication store should contact SEP support to be able to increase the value up to an optimum size for their specific environments.
Required additional amount of RAM and CPU cores
The following tables show the required additional amount of RAM and CPU cores for one Si3 data store. The TB value is the capacity of the Si3 data store.
|It is not recommended to run Si3 deduplication (SEP sesam Server or RDS) on a virtual machine. If this is the case, like evaluation or test, consider to limit the capacity of Si3 data store to 100 GB thus ensuring normal VM operation. Have in mind that deduplication consumes a lot of server resources for reading, processing, and writing deduplicated data, therefore you should be aware of running Si3 on a VM deployment limitation.|
|Si3 data store capacity (check initial size restriction)||RAM|
|<20 TB||16 GiB|
|20-40 TB||32 GiB|
To find out how much RAM is required by Si3 at which capacity, enter the command sm_dedup_interface propose jvmconfig <Si3-CAPACITY> at an admin command line (you must set sesam profile to run the command). The MaxDirectMemorySize output is the required RAM value.
The following table shows the amount of CPU cores required for one Si3 data store. The TB value is the amount of backed up data (before deduplication)!
|Backed up data (before dedup)||CPU cores|
|Keep in mind that the stated requirements represent the demand for deduplication only. In addition to these requirements, the amount of memory for the operating system and other services should be taken into account.|