4 4 3 Beefalo:Step 3: Storage Hardware - Drives and Loaders: Difference between revisions
(Cloned for Beefalo and fixed formatting, navigation and footer.) |
(Marked this version for translation) |
||
Line 6: | Line 6: | ||
==={{anchor|storage_hardware}}Step 3: Storage Hardware - Drives and Loaders=== <!--T:2--> | ==={{anchor|storage_hardware}}Step 3: Storage Hardware - Drives and Loaders=== <!--T:2--> | ||
<!--T:3--> | |||
{{Template:GUI Beefalo Redesign/en}} | {{Template:GUI Beefalo Redesign/en}} | ||
During installation SEP sesam checks the SCSI-connected storage devices and enters their data into its database. This auto-detection works for most devices, but for certain types of loaders the connection between a loader and the drives cannot be recognized automatically. Such devices must be manually verified and entered into the configuration. | During installation SEP sesam checks the SCSI-connected storage devices and enters their data into its database. This auto-detection works for most devices, but for certain types of loaders the connection between a loader and the drives cannot be recognized automatically. Such devices must be manually verified and entered into the configuration. | ||
Line 37: | Line 37: | ||
[[Special:MyLanguage/4_4_3:Configuring_a_Loader|Configuring Loaders and Drives]] | [[Special:MyLanguage/4_4_3:Configuring_a_Loader|Configuring Loaders and Drives]] | ||
<!--T:48--> | |||
{{Footer/en}}</noinclude></div></translate> | {{Footer/en}}</noinclude></div></translate> |
Revision as of 09:31, 12 April 2019
Step 3: Storage Hardware - Drives and Loaders
Note | |
In order to improve usability, SEP sesam GUI has been redesigned to be more user-friendly without significantly changing the interface logic. SEP sesam documentation update (such as screenshots) to reflect these changes is being done in a phased manner, therefore the screenshots may still show the GUI from previous versions. |
During installation SEP sesam checks the SCSI-connected storage devices and enters their data into its database. This auto-detection works for most devices, but for certain types of loaders the connection between a loader and the drives cannot be recognized automatically. Such devices must be manually verified and entered into the configuration.
SEP sesam displays automatically detected backup devices in GUI: Main selection -> Components -> Loaders. All detected loaders are displayed; you only need to select a loader to review its properties, and then click OK to confirm the loader configuration. It is highly recommended to set the Auto unload function to No.
Note | |
When using Windows, the hardware must be recognized correctly by the operating system in the Windows Device Manager (must not be shown as Unknown Medium Changer) before SEP sesam is installed! |
For the drives, an analog procedure is applied. You can view the properties of each drive in the Main selection -> Components -> Drives -> Drive groups. The default drive group is Tape drives.
If the drive characteristics in the field Loader states No loader but should be serviced by an autoloader, the drive was not recognized/configured properly. You can enter this drive into the configuration location in the drive properties by clicking OK.
Note | |
The first drive in the loader is drive 0. If there are more drives in the loader, they will be numbered sequentially. |