Step 3: Storage Hardware - Drives and Loaders 4.0

From SEPsesam

Step 3: Storage Hardware - Drives and Loaders

During installation SEP sesam checks the SCSI-connected storage devices and enters their data into its database. For certain types of loaders the connection between loader and drives cannot be recognized automatically. In this event these devices must be verified manually and entered into the configuration.

To enter devices manually use the SEP sesam GUI function GUI->Components->Loader. To perform this operation open the referenced GUI window where the previously configured loaders are located. Each loader is marked and its properties are entered. With OK, the device is finally entered into the configuration. It is highly recommended to set the "Automatic Unload" function to 'NO'.

Note

When using Windows the hardware must be recognized correctly in the Device Manager (e.g. not as "unknown Media Changer") before SEP sesam is installed!

For drives, an analog procedure is applied. Properties of each drive are selected via GUI->Components->Drives->Drive Groups. By default, the drive group Tape_Drives is selected initially. The SysAdm can accept this setting or enter a new location.

If the drive characteristics in the field 'Loader' state "No Loader" yet it is supposed to be serviced by an autoloader, the drive was not configured properly, i.e. not recognized properly. You can enter this drive into the configuration location simply by selecting OK.

Note

The first drive in the loader is Drive 0. In the event there are more drives in the loader they will simply be numbered sequentially.